Does this project spark your interest?

A

April155

Member
DIPFORTy1 "Soft-Propeller" Zynq-7, Dual CortexA9+ FPGA
DIP40 Parallax Propeller I compatibles footprint
DESCRIPTION
I have used Basic Stamp I, Scenix SX, all done by CHIP Gracey. I have never used Parallax Propeller, but now I will, implemented in FPGA logic, as Soft Proppeller.
Thank you Chip for releasing Propeller 1 verilog source code.
Of course this DIP can be used small FPGA board or Microcontrolller with custom periperals thanks to the ZYNQ on board.
DETAILS




System Design
1176861439735660331.jpg

Main Components/Features
  • Xilinx ZYNQ-7000
    • Dual ARM Cortex A9
    • 256K OCM RAM
  • 16MByte Flash, also useable as linear ROM
  • MicroSD Socket
  • Sil1143 Proximity and Ambient light sensor
  • RGB LED
  • DIP40 (Reversible pinout, not burning is inserted wrong!)
  • 3 times 5x2 pin-headers
    • JTAG + 2 I/O
    • 6 I/O
    • 4 I/O
  • Open Source Hardware
Licenses
  • CERN OHL
    • Hardware design
  • GPL
    • Propeller 1 Verilog
Note: propeller verilog was released under GPL, later there was offical statement on Parallax forums that commercial use is also acceptable without need to stick to GPL. This should be verified however. It seems some old forum threads have vanished. In any case once release under GPL can be used under GPL as this can not be revoked. And the use of Propeller code is not all required, it is just on possible use case.
COMPONENTS
  • 1×XC7Z010Logic ICs / Programmable Logic: FPGAs
  • 2×EN5311Power Management ICs / Switching Regulators and Controllers
  • 1×RGB LED
  • 1×si1143Sensors / Proximity
  • 1×S25FL127SABMFV10
  • Memory ICs / FLASH Memory
  • 1×microSD socketmicroSD socket
  • 2×IR LED0402
 
Back
Top