Hi,
This is my first quad, bought the 3dfly kit from Hovership. Had it up and flying this morning, by late afternoon I decided to flash it to Cleanflight. The Cleanflight app recognized the board, then I selected the newest stable Naze firmware and hit flash firmware. It started to flash. Two or three steps in it failed. Unfortunately I didn't see the error message. I immediately tried again, reviewing my settings, but the board will no longer connect to anything and will no longer even go through its boot sequence.
I read that the Naze boards have a bootloader short option, but I don't see anything like that labeled on this board. I found an old user manual that did lable two open pins as "boot". I took a chance and shorted the two unlabeled pads at the top with no luck. I can't get the board to connect at all now.
I followed these instructions:
https://github.com/cleanflight/cleanflight/blob/master/docs/Board - Naze32.md#recovery
Any ideas? Or did I kill it?
Thanks
This is my first quad, bought the 3dfly kit from Hovership. Had it up and flying this morning, by late afternoon I decided to flash it to Cleanflight. The Cleanflight app recognized the board, then I selected the newest stable Naze firmware and hit flash firmware. It started to flash. Two or three steps in it failed. Unfortunately I didn't see the error message. I immediately tried again, reviewing my settings, but the board will no longer connect to anything and will no longer even go through its boot sequence.
I read that the Naze boards have a bootloader short option, but I don't see anything like that labeled on this board. I found an old user manual that did lable two open pins as "boot". I took a chance and shorted the two unlabeled pads at the top with no luck. I can't get the board to connect at all now.
I followed these instructions:
https://github.com/cleanflight/cleanflight/blob/master/docs/Board - Naze32.md#recovery
Any ideas? Or did I kill it?
Thanks