Anyone familiar with the dys F4? Got a quick question

Jadams453

Jadams453

Well-Known Member
I bought 2 of the dys f4 FC's the other day, they just came in so I want to start getting them installed on my quads. I'm using a Flysky fs-i6 TX with fs-ia6b RX running ppm. I have had a couple different people, who are much more knowledgeable than myself, tell me that the PPM signal pad on this FC is different from where the wiring diagram in the instruction manual shows it to be. Can anyone please tell me where I need to solder my rx signal wire on the FC in order for it to work with ppm?
 

Attachments

  • IMG_1393.JPG
    IMG_1393.JPG
    98.2 KB · Views: 4
  • IMG_1394.JPG
    IMG_1394.JPG
    117.5 KB · Views: 2
Download the pdf file for the board.
If that is wrong then pfff.
That diagram matches the board so who said it was wrong. Have you googled any other wiring diagrams or tubed it.
 
Don't think the PPM pad is different than the diagram, just in a different location than the V1 board. Just wire it up as shown in the manual and remember that with PPM, you don't enable serial rx UART in the ports tab.
 
RENOV8R said:
Why are you connecting PPM when the fs-ia6b has I-Bus? Far superior
Click to expand...
If for some reason like me even after nearly 2 years has given up on it.
Followed step by step instructions but it nvr worked. I updated the firmware to 10channel to get which gives you 18 on ibus ffs. 18.
 
Back
Top