soldering

  1. flyboyfpv

    Soldering Tips for Beginners

    A few soldering tips I put together. Nothing too technical.
    • flyboyfpv
    • Thread
    • beginner tips drones fpv quadcopter soldering soldering tips
    • Replies: 0
    • Forum: Newb Guides
  2. AndreasS

    How to power the Omnibus F3 from my PDB?

    Hi, I have a few questions regarding my connections. I'm not 100% sure if I have done it correctly. :) I have already soldered it up, but I have made this illustration to make it clearer.. i hope. The components showed: PDB Diatone v8.3 FC Omnibus F3 FrSky XM+ 1. To take the easy thing...
    • AndreasS
    • Thread
    • diatone v8.3 omnibus f3 pdb power soldering
    • Replies: 4
    • Forum: First Build
  3. IsaacS

    Need help with PDB and where to solder!!!

    Hey all, I have a Matek Systems PDB (Found Here), and I also own an Eachine FPV camera (Found Here) and an Eachine VTX (Found Here). The PDB has a 5V, 12V, and two Ground pads. What do I connect and where? Thanks in advance.
    • IsaacS
    • Thread
    • 12v eachine fpv ground pdb racing quad soldering vtx
    • Replies: 11
    • Forum: First Build
  4. IlKaffeelI

    How to repair this...?

    Can someone provide some inside on how to fix the problems shown in the pictures? 1. I don't know how I would solder the battery wires back to the connector without damaging the insulation. 2. I could solder the two ends of the wire together, but the solder would be located at the hole in the...
  5. Jadofsky

    First LED Wiring

    Hello all, I got my quad about 2 weeks ago and am having a blast flying it,its the Diatone Crusader GT2 200, and I want to add LED for orientation. The FC is the Diatone D-Link F3 V2 (see below for image) and I have purchased the Lumenier LED system (see below for links to parts). I am a...
  6. C

    Cheerwing CW4 Controller Antenna Mod

    I opened my Cheerwing CW4 controller and spotted the 31mm 1/4 wave antenna. I modded it with speaker wire, twisting it to the original antenna, and cut the total length to 12.5cm. So it should be 1 wavelength now. I have a few questions from those before me who have modded 2.4GHZ antennae...
  7. D

    Replacing the Connector on a Balance Charger

    I'm sorry this is my first time on this forum, hopefully this is in the right place. Regardless, I purchased my first balance charger for LiPos and other battery types, however, all of my batteries use the XT60 connector but the charger only has a Deans connector. Would it be safe if I...
    • Dylan
    • Thread
    • charger charging charging connectors connection lipo battery charging soldering
    • Replies: 2
    • Forum: General Discussion
  8. F

    First time soldering

    So I need to solder my motors and speed controllers, so first I tried soldering for the first time on some spare wire. What i did was i twisted both the wires together (without the insulator) and clumped them into a ball and soldered, or should i say tried to solder... I attached a picture of...
Top