setup

Hello friends, my 2 month old Zino 2 aren't able to fly far than 300m :rolleyes: from the start point due to activating of the RTH without the reasons. There the last firmware is installed on the drone. The batteries are full charged. The control signal is strong. The amount of GPS satelites is...

I can't get the quadcopter to respond to the remote. But I can get the motors to work in betaflight using micro usb. Also no input from remote when in betaflight but gyro works.

Hi. My first post here. I have a Eachine Falcon 250 with a broken vtx. I bought the tx526 from banggood as im allowed to use Max 25mw in my country. The new vtx has 5 cables in one connector whilst the old one had 6 cables over two connectors. Im stuck at how to connect the thing and the cc3d...

Hi all! Hope someone with greater knowledge here can help - I am close to completing my first quad build based on the following: Diatone frame cc3d board Afro ESC controllers multistar elite 2204 motors Everything is built out ok, the board is flashed to match the version of openpilot but when...