calibration

Hello, I'm having a problem with my DIY drone for a very long time. The problem is that the drone's motors work properly and evenly in the motor test, but whenever I try to operate it with the remote controller, the drone tilts and flips before it takes off. I'm pretty sure the motors and...

Hello! I am new to the community, I own the Dromida Ominus Q200 quadcopter and I have't used this copter in months due to this issue. The issue is that whenever I go to fire up the quadcopter, it all connects fine and when I throttle up, the front 2 motors receive more power than the 2 rear...

So was wondering if anybody could help me with how I would calibrate my transmitter and copter on my udi RC 28 - 1 Kestrel? I've flown it about four times and I've lost two of them in the process! So a neighbor finally gave one back that he found when walking his dog and it seems to be working...

Good Day, today i finished the building process of my new quadcopter. Naze32 Rev6 Full S550 Frame 30A SimonK Esc 100KV Motors 1045 Props So the building part is done, all is neat and like i want. I started the calibration and the initial setup. Flashing Naze etc. I use a Turnigy 9xr...

My first build is a 250 with a CC3D flight controller and a FS-t6 transmitter/corresponding receiver. I have been able to successfully calibrate the quad using the libre pilot software. However once i get to the transmitter setup wizard i cant successfully setup the transmitter. The software...

Hello! I'm very new to the hobby, and have a question. I am enjoying my Mosquito Drone (Sharper Image). However, I've found it difficult to control at times. It seems to drift off when I control it straight up. Is there a way to calibrate these controls? Also, the instructions that came with...