arducopter

  1. O

    Motor test - Test all motors in sequence not working

    Hi I am new to Quadcopter. Recently, I built a F450 frame quadcopter with APM 2.8 and I use Mission Planner 1.3.45 with ArduCopter firmware V3.2.1. I do a motor test, all works for me except test all in sequence. When i test all in sequence only the first motor (top right) spins, then nothing...
    • Ooi
    • Thread
    • arducopter ardupilot dji f450 mission planner
    • Replies: 0
    • Forum: Newb Guides
  2. J

    First drone build - Unstable, keeps dropping

    The flight controller is flashed with Ardupilot, so I'm using Mission Planner for all configurations. The issue I'm having is that whenever I push the throttle to the center or above 50% the drone takes off. However, without me moving the throttle up or down, it keeps falling down after...
    • joe809
    • Thread
    • arducopter ardupilot first drone mission planner
    • Replies: 1
    • Forum: First Build
  3. J

    First Build Advice

    Hi All I'm after some advice, A, as to if I have all the parts I need and B, validation that what I have listed can all work together! This will be my first build so I'm not expecting it to be amazing by any stretch! Frame and landing gear Rcmodelpart-Quadcopter-Fuselage-Version-Landing...
  4. R

    Building a processing sketch controlled Arducopter

    Hello! I am looking for a step by step, for newbies, hardware & software tutorial, which explains the building of the following type of Arducopter (very similar to what this guy did, but without the smartphone part: ): 1.An Arducopter (Arduino based quad copter) that has a payload capacity of...
    • roineust
    • Thread
    • arducopter arduino copter payload processing quad uav
    • Replies: 5
    • Forum: Build & Tune
Top