Search results

  1. S

    PLEASE HELP ME! TINYWHOOP WONT FLY

    I AM AT MY WIT'S END! I have been trying to make my first tinywhoop(though I have successfully made several 5in racers) work for 4 months now and i am just at a loss for words. No matter what I change, it never has enough power to get more than 3 inches off the ground at full throttle. Here...
  2. S

    Brushed FC won't see motors or use accelorometer!

    Hey, Sven here, and I'm stumped. I'm using a Betafpv flight controller, and in Betaflight, the accelerometer isn't functioning. Also, when I go into the Motor tab and raise the "Master" slider, but none of the motor bars or motors move. I am so confused, please help!
  3. S

    Escs not working right.

    So I just tried all that and nothing fixed it. I’m at a total loss for words at this point. It’s just super stressful.
  4. S

    Escs not working right.

    So I should solder the ground wire too to the fc? And, also do I calibrate them normally in cleanflight or do I need a special firmware?
  5. S

    Escs not working right.

    Hey, I’m working on a 5in miniquad and have just run into an issue. I just moved to Mystery 30a escs and I am having trouble with using them with Cleanflight. As far as I know from my searching, is that I need to select the PWM option on the motor protocol option, and I’ve been recalibrating...
  6. S

    Gyro malfunctioning?

    Hi! I’m a first time builder and I am struggling. My quad is all ready and built, but now when I rev it up it rotates as if it is turning, but very rapidly. I was too scared to rev it up more in case it gets damged. I figured it might be a gyro problem or an accelerometer issue, but maybe...
  7. S

    Naze32 won't connect to receiver.

    I built it my self, and yes, it is spectrum brand
  8. S

    Naze32 won't connect to receiver.

    Hi all, my Naze32 has been acting up lately. I am trying to connect it to my fsi6 receiver and transmitter via pwm, but on cleanflight I don't see any differences in the channels when i move my sticks on the remote. I don't know if this is an issue, but the flight controller is Spektrum...
  9. S

    Cleanflight Computer crashes

    I’m running windows 10, and I’ll try that! Thanks!
  10. S

    Cleanflight Computer crashes

    My computer is a pc, and I can’t tell if it truly crashed, but when I turned off my monitor and turned it back on again it still had no signal
  11. S

    Cleanflight Computer crashes

    Hey all! I’m a noob when it come to this stuff, and I have been struggling with this. I can get my computer to connect to my Naze32, but only for about 2seconds and it seems that it doesn’t do anything in response to my rotating and tilting the board. After those 2seconds, my monitor goes...
Top