Search results

I have the CC3D and Multiwii. The multiwii is great for custom stuff like gps and the CC3D is very easy to set up and very reliable and cheap. If youre good at programming you could get some arduino uno's and some barometers etc and make a fcb that way. I suggest learning from the CC3D and when...

Thank for your reply, I checked there and all seems to be fine. Im using the screws that came with the motors so i hope theyre the correct length

Have just watched back the flight footage and realised the loud vibration noise and crash took place about 15 seconds after a long bout of full throttle ( 4-5 seconds) which i dont normally do. If this ads to the evidence that it may be a faulty esc please let me know. Is there anything i can do...

So iv crashed my quadcopter many times, however the last two times have been the exact same but i cant figure out the cause. I suspect its a possible faulty esc. Im using 20A Afro ESC. Both times i was flying for longer than usual, 10min<. Both times I was flying aggressively during the flight...

Hi I was just wondering if it is possible to control a servo using the potentiometer on my tx. It's a tgy i6. My fcb is the CC3D. If it's possible, how would I go about it? Do I connect the servo to the reciever or the flight controller? My reason for wanting to do this is so I can mount my...

So iv 3D printed a 2 axis servo gimbal for my quadcopter. I have put it all together only to realise one problem. How do you get the servo that controls the roll to have a strong and secure connection to the rest of the gimbal?? For example https://i.ytimg.com/vi/dOu_MZyWr8w/maxresdefault.jpg...

Thanks for the reply. So if i got that larger ppm rx it would increase my range? Interesting, thanks

ah sugar typo sorry.. Meant RSSI (radio signal strength indicator)

For high altitude fpv flight.. Would it be better to have your fpv camera facing forward or facing straight down? I presume you don't get to see how much you're drifting away if you're high up and your cam is facing straight ahead.. Could be deadly for losing signal.. Thanks in advance

I'm very conscious of running out of range with my quad and was wondering what kind of distances ye get with the tgy i6? As it has no fssi. Thanks

It was a very cold day today and I re tested the range, I got to the point where the noise was too much last time and I still had clear picture (around 100m) so I think temperature is a big factor. This was also still with the 3s, as the connector for the tx is a 3s balance comnector so I...

Ummm actually yeah when I turn the tx (turnigy tgy-i6) on Theres a picture of a plane just under the tx voltage on the right.. Could this have an effect?

Haha you catch on after a while

Thanks I'll look into that. I use the CC3D

Thanks for the reply, but I'm not sure I understand. If I correct this by increase my P and I values will that not increase the wobble in the quad?

Throttle on the left so.. Mode 2 I think Yeah

It seems like a pitch forward and very very slight roll to the right

Also there wasn't too much wind, I don't think it was much to do with the wind as the quad turned from going straight up almost instantly

So when I was flying my s500 today with a 4s 5200Mah lipo and 935kv motors I decided to have some fun and go full throttle a few times starting from just a few meters off the ground. All was well except as the quad rockets upwards on full throttle it goes quite a bit off course, as in doesn't...

Nope always had the antenna on when the battery was plugged in