Search results

And the money goes to Dugdog47!!! I flashed Betaflight 3.1 and everything is working as intended! I am really grateful for everyone's help, this is a fantastic forum for beginners P.S. If someone can mark this thread as solved or let me know how to do it that would be great!

Sounds good, I'll try flashing with an older version of betaflight (3.1 probably) and if that doesn't work go to cleanflight 2.5

Yes, it has the spracing f3 board. I would like to use betaflight instead of cleanflight if possible because I've seen that it just runs better on the wizard. I flashed it with version 4.0.1 of betaflight I believe. Do you know why betaflight would only not be working for the motors? Every...

Could you explain this a little more for me? I'm not quite sure where "Device Drivers" is or how to very the com port setting. I made sure betaflight wasn't connected as well and tried BL Heli again with the same error message posted above.

Thanks for that information, When I downloaded that app and connected my quad, I tried to read setup and got this message. This version of BL Heli looks very strange to me so I'm not even sure if I have the right version but it seems like BL Heli can't read my ESCs either... Any ideas on what...

I have tried BL Heli before (the one through the chrome extension) but I don't seem to get any tabs on the side when I launch it and connect to my FC. Here is a screenshot of what I see when I connect and power up the escs and then hit read setup. It says reading setup finished in the top left...

Thanks for your reply, I have tried every different motor protocol on Betaflight (oneshot125, Dshot, etc.) with no luck. I also reflashed the FC with Betaflight previously and reset settings to defaults but the problem still persists. I tried to calibrate my escs as well but since the motors...

Nope, just the three beeps showing that the escs have power but not the other two showing a connection to the FC. I'm not sure why the FC wouldn't be receiving a signal from the escs though unless the quad was doa because it was brand new a couple of years ago and has never been flown...

Hi all, this is my first "build" and first post on the forum. I say "build" because I have an old Eachine Wizard 220 that I got a few years ago but has never worked. Originally I couldn't get any stick input in Betaflight but I replaced the Flysky receiver with the Fli14+ and switched the...