Recent content by thelakes

i tried and the emax 2205 2600 kV can lift a laptop well can pick half of it up until the usb disconnects and the laptop smashes to the ground haha

all aspects of it im struggling to just take off and fly how do you know where the ground is etc

my mistake there 2600Kv

Hi Guys, So after about 4 months of building tuning hitting so many different issues both technical, hitting things and completely losing my first Quad :(. I decided to build my own 250 fpv quadcopter. so my set up is ZMR250 frame CC3D Emax RS2205 1600 Kv Afro 4in1 20a ESC Boscam 200mW Video...

its a mini cc3d. when i connect the battery the blue light on the front right flashes rapidly, when I hold yaw left for 5-10 seconds the blue light changes to a slow flash so i know its definitely arming

Im using libre pilot and everything seems to work as it should the only problem i can only get the motors to spin whilst my usb cable is connected as soon as i disconnect from my pc all i can do is arm the quadcopter but i cant get the motors to spin anyone know why this is?

I downloaded librapilot ran through setup wizard and transmitter wizard an it worked flew with my 1 battery worked fine went to the 2nd battery had a 30secondish flight landed didn't take off for a while so it disarmed itself I re armed it but nothing again it arms but nothing works again. So re...

haha a pain is the polite way of putting it. this is my first build ive enjoyed it and through trial and error sorted other issues so i hope i will get it sorted. If... when i fix it ill post what i did so it will hopefully help others in the future

yes everything is connected correctly... i think when i run set up wizard in openpilot i calibrated my esc i can set them all they run at 1116, when the battery connects they make the right beeps all the tutorials ive watched seem like its all done correctly. are there any good youtube videos or...

yes the arming process is yaw left and it does arm cc3d goes from rapid blue flashing i arm it and it goes to a slow blue flash.

hi so I've finally got my quadcopter working with setup wizard on openpilot now my next issue the transmitter won't work. It binds ok but nothing happens. When i use transmitter wizard on open pilot i set it to mode 2 and when it says move the throttle stick nothing works but if u move the right...

i think you just need to rebind your transmitter did the eachine come ready to fly or did you bind it yourself ?

im just getting constant beeps occasionally one or two will make the right sound but then they just start up but only motors 2 and 3

yer ive tried it no joy ive searched the internet and nothing seems to work im wondering if i just buy some new ones

is lebrepilot better than openpilot? do you think this will help? i suppose its worth a try