Recent content by Michael Gauthier

No luck so far. No matter what I do, I can’t get the receiver working in Betaflight. It is bound to the transmitter and the built-in LED does light up indicating a connection when the transmitter is turned on. Some instructions/people say hook up the signal wire to Tx others say Rx, I have...

If the SRXL2 receiver doesn't work, what about the Lemon DSM2 compatible receiver. Where does that signal wire connect on the T-Motor F7?

I have a T-Motor F7 55a Pro II stack and a Spektrum SPM9747 SRXL2 receiver. I can't find a wiring diagram for how to connect these two together. The SRXL2 receiver has 4 pins, Ground and 3.3v but I don't know what the other two wires are nor where to connect them on the F7.

I looked in the Betaflight configurator and there is no board for NAZA-M V2. Is there any way to use this controller with Betaflight?

The are dozens of F4 flight controllers out there. Some say nothing about Bluetooth and WIFI and some say one , the other or both. I want to fly with my trusty Spektrum DX8 transmitter and a DSMX receiver. I am guessing those would work with just about all controllers and that mentioning BT and...

I want to build an FPV drone with 4"-6" props, and need to know what flight controller would be good for stable video and 3d flight. Most likely going to be using BetaFlight. I saw something that says F3 flight controllers no longer get new features due to lack of resources. I see there are a...

I want to build my first non- pix quad and it will also be my first 3D drone. It will be in a 450 size frame. I’m just not sure what flight controller or stack would be appropriate for that. Anyone want to suggest something for that?

I would normally charge these batteries with my lipo charger, but I figured I would check out the little charger that came with it. Since the 4-pin connector was wired correctly, it didn't know anything was wrong. Like dragger201, I will be checking new batteries in the future. I am certain...

I bought this kit from Amazon (not faulting Amazon) https://www.amazon.com/QWinOut-Drone-Quadcopter-4-axle-Aircraft/dp/B01HEQQDNK/ref=sr_1_10?s=toys-and-games&ie=UTF8&qid=1499199539&sr=1-10&keywords=drone+kit+flysky The battery in this kit is an FMT 3s LiPO. The + (red ) and - (black) wires...

The goggles are Eachine VROO7 Pro and I think they may be usable if I had a good camera. The camera has no marking on it but it is low resolution and uv blinds it as does bright light. It doesn't handle light variances well at all. It is a tiny thing with a single 7-segment display on the back...

I'm currently flying a DIY 450 size quad with a Pixhawk P4 controller. Beginning to get the hang of it. I bought a $99 FPV kit to try that out, but it is absolute total junk. It's not even good enough to get a sense of what FPV is like. The picture is washed out for about a 3rd of the view...

I bought a new spektrum receiver an I am using that cable. The ones from Hong Kong will be here in a week or so, so I am back to flying.

I need a 3 position df13 cable to connect my Spektrum receiver to the Pixhawk P4. Does anyone know of a U.S.A. supplier that can deliver these in a day or two. I can get all I want from China, but shipping takes a long while.

Thanks all!

Renov8r, you don't show a SBUS pin and my cable only has 3 pins on both ends of the cable. This is an SPM4648