Recent content by Leadlicker

interesting, when i try betaflight an error message says something about unsupported firmware. i was getting farther with cleanflight. its an SPracing f7 dual so i beleive it was a cleanflight specific FC. anyway the quad is up and "running" it just wont fly, my motors seem to calibrate just...

my FC will only run on cleanflight.

I soldered my bad connection and it all works but seems as if the motors are not calibrated or i have a funky setting somewhere. it wouldnt even take flight. it just spun in circles.

i cant bang my head against the wall because it doesnt help with soldering..... thanks for that suggestion i will do that.

i just changed a throttle threshold and it worked but one motor isnt spinning, now to check solder connections

i dont have failsafe enabled either, and I think that is one of the flags saying its enabled. i really just need a good walkthrough on how to set this up but there isnt one for cleanflight.

yes my aux1/ ch.5 is for arming and it works in the tab. im getting arming flags of 6 and 10. this is with or without the usb plugged in, but most importantly when im not plugged in to the usb port. For some reason it isnt arming and the nice video i just watched doesnt have the issue. I have...

I got the radio controller to respond in the cleanflight menu, possibly a combination I have yet to try. all I did was disable telemetry in the ports tab, I'm using uart 2. still however, there's the issue with the radio controller not spinning the motors. my fs-i6 controller will also not bring...

I have built my second quad and its just had me stumped. Its a 3-4" frame from getfpv.com and I dont remember the name of the frame. the FC is an spracing f7dual, lumenier 18A 32bit silk esc's, emax 1806 motors (from the wrecked robocat250 i built), an FS-A8S rx, and im using the flysky FS-I6...

I've been looking for opinions here, but I can't seem to find what I'm looking for. I'd like to know what props people are using. I have some gemfan poly fiber 2 blade that are decent, and some abs triblade that are much worse. Have not tried the spendy carbon props, but so far I like the 2...

I can do that, but I resoldered to clean it up anyway.

"I admit that the signal/servo wires were too short so I soldered a longer set right to the board. I think I put too muchsolder and they were touching." This was on the new lumenier esc.

I will clean up my wiring, switch my #2,3,4 wires around so they spin the proper direction and I WILL have some fun. And for the record, all of my lumenier escs ARE good because I just got it to work on that problem motor. It must have been bad soldering again possibly, but that one emax nano...

Well I made progress. I soldered a working emax nano esc to the motor on ch 1 of the cc3d atom I stated wouldn't work and voila! Wtf it worked. Maybe in the past when I did this I could have been so frustrated that I didn't do a good job of soldering. I've done this before and nothing, but just...

I'm still working on this. I haven't had time to fiddle with it. I will keep posting progress if I make any.