Recent content by hug_dealer :D

So Sigh... johnny 5 if only this drone was as simple to understand as you x

lmao... but help me plz :)

ok so i didnt realise but the props were incorrect! i had a suspicion on that. but now when i tried flying it it instantly backflipped? why could that be?

any high capacity 40c 3s lipos you could reccomend?

Managed to get to full stick and quad started shaking. Motors are spinning righy directiom do maybe props? Also what c rsting do u reccomend?

With battery it is 1.236 kg

In english plz? Drone noob here. Using pixhawk and main outputs not the aux ones if that helps? As well as ardu pilot

Hey guys... first time i fired the quad up all is well.... but it wont lift off... Using emax 935 kv motors with 10x45 props. (Yes they are mounted in the right direction!). My battery is the 3s tattu 5100mah 10c lipo. Could it be the c rating (so there isnt enough current) i have 4x20A esc's...

Hi all, finished the build and turned it on... but one of the motors is acting funny? when i put the throttle to about 1/4 up it spins but then slows then speeds up and slows... is it the esc or the motor? first time build noob so i dont know what to do :/

ok so.... i know i need to connect the vtx's 3pin header into my camera.... but my camera has 4 pins and im usign the minim osd in between.... none of the cables seem to fit together kmn.... HELPPPPPPPPPPPPPp

using a pixhawk flight controller.... only issue is i dont see any way i can connect the osd with the camera and stuff.... need help asap. i dont want this money to go to waste :(

Please help???

Hi all, Current build progress is going okay... i am just about to wire up the fpv system. but i think the parts are incompatible!!!! Parts: Mini osd - https://www.unmannedtechshop.co.uk/ardupilot-mega-minim-osd-v1-2/ Tramp HV -...

Thanks! as for powering the pixhawk do i need a power module? can you reccomend one?

using a pixhawk and yeah that looks fine... how does the osd work? also i have ordered everything but i am unsure about the 10 inch props how do i know they will fit without physically testing?