Recent content by Eastbayboy

Finally got it working and betaflight/FC recognize the configuration. But I may have other issues relating back to what I heard on the videos for flashing firmware. I flashed using the target IFLIGHT_F405_A10 version 4.2.8 and in the release info there is a line stating Unified Target. Unified...

The version is STM32F405 and there was only one option. The oldest version listed for STM32F405 is 4.0.4, which I tried and it still did not work but there was a change. After flashing with the newer versions and connecting an error always came up stating there was no ESC protocal selected...

Wafflejock, I think I am near the end in a bad way. I tried all you said with no luck. I could never get beatflight to ask to apply the board config. This is what I did maybe you can see an error in my approach. 1. Successfully flashed firmware (4.8). 2. Wait 60 seconds and disconnect the USB...

Thanks for the input guys!! Well I did try flashing the firmware with serveral different version (4.6, 4.7, 4.8) and no change. I wrote down the target version before I started, so that was good. I also followed the instructions in the video for reloading the board configuration (go to CLI...

I am trying to set up a iFlight Succx-A10 F4 flight controller with BetaFlight and was hoping for some help. I initially hooked up the FC to BetaFlight via USB and all looked well. When I moved the Quad around the Setup page display showed the quad moving also. I then successfully flashed the...

I am trying to set up a iFlight Succx-A10 F4 flight controller with BetaFlight and was hoping for some help. I initially hooked up the FC to BetaFlight and all looked well. When I moved the Quad around the Setup page display showed the quad moving also. I then successfully flashed the FC with...

Many thanks Badfish, it worked!!! Now I have to setup all the other parameters Eastbayboy

Ok, I found the TX6 and also a RX6 pad in the middile of the board. So I need to move the reciever serial data line to the TX6 pad? Right

Yes the battery was plugged in and charged. I did use the plastic screws provided with the FC.

Thanks all in advance for helping to get my drone working!!! I am a Newbie building my first quad and first time playing in the RC world. My problem is I can’t get any response on Betaflight between the flight controller and transmitter. I have followed instructions on numerous videos but no...