Recent content by Aytekin Akkaya

Interesting, i have never heard about it! I will search for it. I have already bought the propellers; 15x5.5 Tarot Carbon Fiber Prop Propeller CW/CCW DJI Multi-copter this is biggest i can go with the shaft. I bought these because of the system efficiency. There is a table shows the efficiency...

Well, this will be my first project, and i have been researching for the optimum settings; flight time, power, etc. So these are the components i found for reasonable prices for my project.

Gartt ®6pcs ML3515 400KV Brushless Motors for Multirotor Multicopter

These ESCs should support up to 6S (at least this is what the seller claims) which must be okay up to 24 V. But from above explanations, the problem is related with the external DC power supply it seems like. Because i have never tried to power up with batteries. I appreciate to you...

Wires should be connected properly on the board. Black (neutral), yellow (signal), red (+), and the pins are labeled at the back side of the board.

What do you mean by that?

At the very first time, i connected the motors to ESCs, however it did not start up. This is why i started troubleshooting the lines back to control board. on the other hand, the ESC is not connected to a motor, but ESC is connected to Out1 on the control board (signal cable), and to external...

My excuses! Let me clear out this part. I have not purchased the 6S batteries yet. Thus, i am trying to test the equipment with external DC power source(please see attched pic), which can be set up to certain DC voltage. The reason why i mentioned about 19V dc is; -since the external DC source...

Yes, Control board appears to have power, this is how i set up the settings for quadrocopter, Also i was able to check the receiver settings. I am not feeding the controller from the power pins on the controller (please see attached pics), but the ESC seems to feed the controller properly up to...

Hello Fellas, I am working on my first quadrocopter, however i am having hard time at the very first step; 'NO RESPONSE' from control board. I am on the very first step, which testing the equipment if they work or not. It seems like, boards gets signal from remote controller (i can see that on...