Robocat build?

U

upbeat

New Member
Hi, i'm looking to take the plunge into my first 'non-assembled' FPV multirotor. I have had a look through the different builds on here trying to get my head around the combinations, but struggling too.

I was wondering if the combination of components with the first kit on this page here is any good at all (and if it is overpriced?). Will it perform with a 1800mah 4S 65~130C Lipo Pack?

http://www.skyhobbies.com.sg/pagelink_multirotor_airframe_sets_250_Bundles.html

The list of components according to the website are:


Combo Deal included the following:
Robocat 280mm - COMBO
280mm Mini Quadcopter Frame
Combo with OpenPilot CC3D Flight Controller +
- LDPower 2204 / 2300KV Motor x 4
- LDPower 15A ESC x 4 (opto)
- Flight control: CC3D
- Propellers 6030 (2 CW/ 2 CCW)

Selling for about 230 Singapore dollar ~ 165 USD

Thanks for your help, and sorry if I put this question in the wrong place,

thanks,
upbeat
 
Jackson

Jackson

USA member at large
I notice that it's not listed as a Tarot Robocat 280mm. Some sort of copy? Does it have the built in PCB like the Tarot?

07.jpg


Seems the ESCs are opto so you will also need a UBEC.
 
GJH105775

GJH105775

Off and on
Moderator
upbeat said:
Hi, i'm looking to take the plunge into my first 'non-assembled' FPV multirotor. I have had a look through the different builds on here trying to get my head around the combinations, but struggling too.

I was wondering if the combination of components with the first kit on this page here is any good at all (and if it is overpriced?). Will it perform with a 1800mah 4S 65~130C Lipo Pack?

http://www.skyhobbies.com.sg/pagelink_multirotor_airframe_sets_250_Bundles.html

The list of components according to the website are:


Combo Deal included the following:
Robocat 280mm - COMBO
280mm Mini Quadcopter Frame
Combo with OpenPilot CC3D Flight Controller +
- LDPower 2204 / 2300KV Motor x 4
- LDPower 15A ESC x 4 (opto)
- Flight control: CC3D
- Propellers 6030 (2 CW/ 2 CCW)

Selling for about 230 Singapore dollar ~ 165 USD

Thanks for your help, and sorry if I put this question in the wrong place,

thanks,
upbeat
Click to expand...

Looks like it may be a copy, if that does not mater for you then it also looks like your parts are only rated for 3S, so the same battery in 3S would work.
 
U

upbeat

New Member
I've asked the company and been informed that it is an Etech Robocat. Is that a concern?
So it doesn't have the PCB inbuild and will require one. Anything to look out for?

Also when I asked the company if a 4S would work with those ESC, I got the reply that "The ESC is able to handle 4S as it is Opto (no BEC)" is that a correct answer or shall i insist on better ESC's (20A)?

Thanks for your help
very much looking forward to flying and hoping to avoid the pitfall of getting things that don't work together/well so thank you for your help again
upbeat
 
Last edited:
You must log in or register to reply here.
Top