Protocol Dronium III

[Lmckillo]

Good Day .
I have a older Protocol Dronium III . The drone turns on , the control turns on and syncs to the drone . Does what it’s supposed to , move the power stick up then down , two beeps and it’s connected. I then calibrate the drone , lights flash fast then stop when it calibrated.
When I try to start the motors on the drone there is absolutely no power to the motors . Fresh batteries in both the drone and the controller .
Any ideas why there would be no power to the drones motors ?

Thanks

 

[holtneil]

Hi you need to arm the motors most drones need both sticks down and away from each other to arm and same to disarm