Shuff
Member
Hi Folks,
I have just fitted a GPS module to my Naze 32 rev 6 board (CF FW 2.3.2) and am trying to configure the setup without much luck.
The GPS has a good signal and the flasing LED on the GPS indicates a lock, the wiring GPS TX goes to Naze RX in , But I need advice on configuring the software .
The GPS is currently outputting at 9600 and I tried setting the Config tab in CF "Sensor Input" to GPS at 9600. Also tried other setting relating to GPS but I have no info in my main GPS screen in CF configurater.
Has anyone got any ideas on how to set this up ?
Thanks for any help.
I have just fitted a GPS module to my Naze 32 rev 6 board (CF FW 2.3.2) and am trying to configure the setup without much luck.
The GPS has a good signal and the flasing LED on the GPS indicates a lock, the wiring GPS TX goes to Naze RX in , But I need advice on configuring the software .
The GPS is currently outputting at 9600 and I tried setting the Config tab in CF "Sensor Input" to GPS at 9600. Also tried other setting relating to GPS but I have no info in my main GPS screen in CF configurater.
Has anyone got any ideas on how to set this up ?
Thanks for any help.