My first qav250
- Thread starter Noob9875
- Start date
Noob9875
Well-Known Member
Yep motors will be here in the morning and battery that is all I need everything else is on and all works I set the tx/rx up already on openpilot download the new s oftware/firmware to the board so once I get the motors I can run through the setup wizard and hit the park
Noob9875
Well-Known Member
OK so today I whent out to fly and take off is perfect hovers pretty straight doing a little to and froe as I decided to taker up little higher and put some real motion it takes off like a bat out hell then does a flip after I let the stick go u can hear the motors going all out to straight the quad up but just never recovers same results every time I've checked my balance and it still nice and level all props are tight motors are good as far as I know no funny sounds or tight feelings or hitching felling
how windy was it ? you be surprised at the higher altitudes how a freak gust will throw that quad around.
my eyes are getting bad so i'm having troubles seeing your build.
but I had a cc3D flight controller that i did the binding with the ESC's conected and while it would fly it would do the same erratic behavior.
also, keep your reciever as far away from other electrical components specially the ESC's and try shield hardware with copper tin foil,
if running with GPS build a mask / poll and keep it about 3 inches from other components.
check all your electrical for shorts, or burnt wiring.
make sure the battery is not to big , or quad too heavy for the motors have to work harder
with the 250's i run 6" props, 5" will work but it works the motor harder and you won't have the same control.
forgot to mention too but put foam under your controller to dampen vibration, hope this helps