mixed channels

[Degsy]

whats going on here !
new to all this so terminology might be a bit off.
The sticks on my transmitter(Fly Sky FS T6) control pitch/yaw/aux 1 and aux 2 i have tried a few things but can not get the main four (AETR) controlled by the sticks it is always 3 and one Aux.
thanks for any help
receiver - Fly Sky FS-R9b
quad - night hauk pro

 

[RENOV8R]

It looks like your receiver is just connected to the FCB in the incorrect order.

 

[Jackson]

Unless I'm missing something the FS-T6 is a 6 channel TX. So you should ignore the #7 & 8 slots on that RX you are using. Are you?

 

[RENOV8R]

By looking at the receiver levels, channel 1 (roll) is not being used, and 2 to 6 are. Is it possible you missed channel 1 input on your receiver and started at 2? It's like if you backed everything up 1 input you'd be good to go. Can you post a pic of your receiver where the inputs are?

 

[Degsy]

All the wires are in the right place channel 1 - 5 .
I have tried them in different orders but it is always the same,only 3 of the four AETR.
tried to post a pic but would not work. will try again later.

 

[Degsy]

 

[Jackson]

So what exactly is it you are using? FCB and software. May 2015 seems rather old.

 

[Quest]

Looks like your receiver is setup correctly but what about the transmitter does it match?*