Feiyu Tech new Mini 3D Pro Gimbal - Don't Buy!

[Dandan1977]

I have just purchased a new Gimbal and wanted to install on a new Phantom2 since its going to be dual remotes set up.
Initial start up and testing the Gimbal discover this issue
which as seen on VDO makes vibration all over.
Nothing connected just power supply directly to Gimbal.

I am not sure but I think this all shorten upper damper plate design
is not a good idea as the torque from the pan arm become very sensitive

If you look for professional so this is probably not the one:

 

[Jackson]

Maybe you just got a bad one.

Here's the firmware page.
http://www.feiyu-tech.com/products/10/dl/

 

[ringolong]

Maybe you just got a bad one.

I agree with Jackson. Seems to be a defective unit, or firmware is corrupt.

 

[Dandan1977]

maybe....
But first of all this is the "pro" version...therefore I would not suggest no one to try and connect software of the
standard Mini version...on their website there is no updates for the Pro version yet since it is new product
and I have confirmed with the factory to make sure there isn't..

It might be defective for sure...seems like the pan motor touches something or maybe even its pid gains do not
provide enough power to this specific motor.

I do have to say the Gimbal itself feel very firm and solid, much much better (visually) then the H4/H3 Zenmuse

U have agreed with the tech support to ship it back let the check it but send me a new one
after testing it carefully at the factory and make sure they ship me a unit that function flue less.