Check out AD1. Easy to fly with integrated gimbal for GoPro3

[ActionDrone]

I have a few of these I'm going to sell but right now I'm still doing some video editing to promote this quadcopter. Just looking for some feedback. I'm also trying to figure out how to make my wires not looks so open. Any ideas? Also if you can brows through my website any suggestions would help. My business is designed to make good quads ready to fly for everyone or plug and play. I'm basically assembling it for you.

www.actiondroneusa.com

 

[Mike]

Very nice copter. I really like the transparent plate on the top. Everything is simple and elegant and the design looks great. I don't really see a good way of hiding the wires to the camera gimbal motor without adding unnecessary weight. I honestly think it looks good with them where they are.

The site also looks very good and is easy to navigate. What shopping cart setup are you using? Is that Shopify?

Also - any plans to ever sell the frame on its own?

 

[ActionDrone]

Yeah I would sell them just with frame but I had them designed so the gimbal and the gimbal controls go with it. I have not made the instruction manual on how to build it so it might be difficult to assemble it. I'm thinking of just making a video on how to build it. The gimbal is plug and play except when you want to control the tilt and pitch. Then I have to make sure to tell people not add the 5v from the receiver directly to the gimbal cb. But if they just want the frame w/ gimbal and control board I'll sell it for $560 but I would have to assemble it just to make sure that I dont have a problem with people letting me know they can't assemble it.

Right now I'm flying it to capture some videos for the promo video. I'll post it here when its done.

 

[Mike]

Makes sense. Video is probably best for the instructions. Most people are visual learners.

Can't wait to see the video when you post it!