Channel mapping problem.
- Thread starter mozquito1
- Start date
Jackson
USA member at large
So what are the midpoints?
mozquito1
Well-Known Member
I have figured part of it out. It is nothing to do with connections or soldering joints. I must have tried at least 60 combinations of mapping channels, changed stick modes on the Tx. But to no avail. Not much help on the issue either. In multiple forums. Thinking of just selling what I got as I got spare naze but losing faith in the hardware.
mozquito1
Well-Known Member
Hahaha hahaha sussed it out. Cli command rx parallel pwm. It was an overlooked small detail. Thanks to everyone who helped, sme. 3 effing days All those people who had the same problem but no idea, on other forum's to. Well I'm out flying soon as the sun comes up.
Last edited: