RENOV8R
Well-Known Member
So I just got this cute little receiver.http://us.banggood.com/Wholesale-Warehouse-2_4G-5CH-DSM2-Full-Range-Receiver-wp-Usa-1004179.html
Specs say the operating voltage is 3.7-4.2V. It's going to be connected via PPM to UART 2 on a F3 EVO micro FC, however the voltage out on UART 2 of the board is 5V. Will I be OK or am I going to fry the receiver? I'd connect it directly to VBatt as I'm just using a 1S battery, but I've already got my camera connected to it and I don't want to dirty up the VTX signal. Watcha think?
Specs say the operating voltage is 3.7-4.2V. It's going to be connected via PPM to UART 2 on a F3 EVO micro FC, however the voltage out on UART 2 of the board is 5V. Will I be OK or am I going to fry the receiver? I'd connect it directly to VBatt as I'm just using a 1S battery, but I've already got my camera connected to it and I don't want to dirty up the VTX signal. Watcha think?
