qav 250

  1. C

    Suggestions & Advice Welcome: First Quad Build QAV250

    Hi Everyone, I am working on my first quad build. I'll need help with understanding a little into my quad amp requirements and supply with the following parts. Power Supply: Turnigy LiPo Battery: 2200mAh (45C-90C) Assumption: 2.2*45 = 99 Amps Max Draw Power Demand: 4 Arris MT1806-2300kV DC...
  2. Krak-A-Pat

    Need some help....

    So I'm hooked! Flew a DJI last night and started looking into racing drones. Found a site and started to piece together what I hope will be a good learner... Can someone tell me if I am missing something or need different pieces? My build so far ( haven't purchased yet) Body: QAV-Skitzo quad...
  3. S

    Newb here, bought RTF QAV 250 knock off, update firmware and settings - no flying

    Hello All, I am newb here, bought RTF QAV 250 knock off, update firmware and settings - not flying. My quad was flying but very sloppy so decided to install open pilot and update firmware and settings. Now the Quad will run all the motors but does not take off, when I give the full throttle, it...
  4. M

    Motors not responding

    Hey , I am running my first build with a QAV 250 and a Naze-32 afroflight flight controller.I have a problem that when I move my throttle on my transmitter(Graupner mz-12) it has no effect on the motors.However when I connect my Quadcopter to base flight the throttle/yaw/pitch bars move...
    • MAFA-27
    • Thread
    • first build qav 250 transmitter
    • Replies: 12
    • Forum: First Build
  5. Eyes to the Sky's

    QAV 250. Ok for a first build?

    Debating on wheather to purchase a QAV 250 for a first build. I like the look of these and was just wondering any ones thoughts as to this being a good idea? Or any other suggestions on a decent 250 frame for 1st build. I like the pdb on these frames and have also seen somd nice 3d printed...
Top