connection

Hi I was hoping someone can help me with my problem. I have a SHRC H1 quadcopter that's experiencing a problem. I follow the instructions to the letter. WITH CONTROLLER: • turn on drone and place on a level service. The lights underneath the drone flash very quickly. • turn on controller, lights...

I have the AT9 Transmitter and I am trying to set up an external receiver using the R9DS receiver. I can not use the built in FRSKY receiver because the AT9 can only bind to Radiolink receivers.... However, I having issues getting flight controller binded to the transmitter. The receiver is...

Hi. My first post here. I have a Eachine Falcon 250 with a broken vtx. I bought the tx526 from banggood as im allowed to use Max 25mw in my country. The new vtx has 5 cables in one connector whilst the old one had 6 cables over two connectors. Im stuck at how to connect the thing and the cc3d...

Build my Sky Quad Pro V2 today and went out for a Test Flight. First attempt went quite good, only the landing is a bit tricky, not to set her down too hard. I wanted to do a second round, but the drone and remote didn't connect again, even with changing all Batteries of Remote and Controler...

I'm sorry this is my first time on this forum, hopefully this is in the right place. Regardless, I purchased my first balance charger for LiPos and other battery types, however, all of my batteries use the XT60 connector but the charger only has a Deans connector. Would it be safe if I...

Hello so I think im having problems with connections between my tx and rx for my quadcopter. Its a turnigy tgy-i6 and tgy-ia6 receiver. Basically the rx signal drops to zero and sometimes disappears off the screen on the tx at only a few meters distance but the quadcopter still responds to...