Hello everyone,
I have installed betaflight 2.8.0-RC3 on my naze32 rev 6. I have disabled oneshot, and have set a switch to arm and airmode. My pid numbers have been transferred over from the last firmware. However, upon arming, the motors throttle up and the quad starts climbing. The...
Hello everyone,
I have recently tried to get betaflight on my naze32 rev 6, because I wanted airmode on the quad. Upon getting the board sucessfully flashed, I armed the board, and tried to spin up the motors to no avail. The motors didn't make the startup sound, nor did they spin. I tried...
Hello everyone,
I have been flying really hard the past couple of days as the Michigan snows have cleared out. Recently, I was flying over a parking lot doing flips and such until a propeller exploded in mid air, causing the quad to take a tumble. It landed right on the battery and arm. Arm...
Hello everyone,
I've got a 250 size quadcopter here, naze32 rev 6, lumenier 2206 2350kv motors, 5040 props on 4s. When I try to fly it, this little rocket :) does not like to descend. I can't get the throttle low enough. When I reduce the throttle, too low and the motors stop and the quad...
Hello everyone,
I am working on a new 4s build and am currently looking at the following for motors:
T-motor 2204/2206
Lumenier Rx2206 2350kv
Cobra 2204
I want the most power at the lowest cost. The Rx2206 cost the same as a T motor 2204. The cobras are always out of stock so out of running...
Hello everyone,
I am currently trying to build a new 4s racing quad. I've got the emax 20A blheli esc, but I'm looking for a motor. I think I have found a good one:
http://www.ebay.com/itm/171923349248
Does anyone have these motors? Are they any good? If not, any suggestions? I want the...
Hello everyone,
This is my second quad build as my first one flew away for some reason... I am a bit of a noob still.
I am trying to build this second quad to be leaner and faster than the old one with a 4s lipo on it.
frame...