Search results

Yeah, that should work just fine. what ESC's are you running? they need to be 4s capable and 20-30a.

Are you planning on running a 3s lipo? If so, I'd say you should be looking for something with a higher KV, maybe 800-900ish. 620kv is pretty low for a 3s battery. 620kv means 620RPM per volt, so a 4s would spin it faster than a 3s, and 3s probably wont spin that motor fast enough.

this motor from hobbyking looks like a suitable replacement: http://www.hobbyking.com/hobbyking/store/__25555__AX_4008Q_620KV_Brushless_Quadcopter_Motor.html

Another vote for HobbyKing, I use nothing but Turnigy Nano-Techs and have never had any issues with them and I run them hard! I've had a few get puffy (I think that's unavoidable with any lipo) and they keep on trucking!

are you using baseflight or cleanflight? what Tx are you using? That may help us help you..

What flight controller do you use? You probably need to go in to the config for your FC and swap the channel inputs..

If your talking about the props on mini quads, such as 5" or 6" plastic GemFans, then no.. I usually do not balance them out of the bag and they are pretty close to perfect. Once the get beat up a bit i'll use a little tape on one side or the other to balance the prop though.. :)

Check out the PixHawk Clones, you can get a complete setup (FC, GPS, OSD, Sensors and more) for pretty cheap - about $200 - on ebay. http://www.ebay.com/itm/Pixhawk-PX4-2-4-6-32bit-Flight-Controller-Led-w-NEO-M8N-GPS-PPM-OSD-3DR-915Mhz-/261860222511?pt=LH_DefaultDomain_0&hash=item3cf815e62f

I agree, while Baseflight has made some nice improvements in the last few firmware upgrades (including options that are similar to CF OneShot). I think CleanFlight is the way to go, it seems to get more attention, and the devs listen to the community.