Search results

Had the same issue. You should bind to the internal module. My issue was that the radio is FCC (International) And the receiver is EU (LBT) You can bind the receiver, but it is showing constant red light. Flash the receiver or the transmitter in your radio (XJT version) so that they match...

I managed to read out the Processor of the FC. Its not the best picture, but it says: ARM2 STM32F.405 RGT6 GH21K VQ CHN GH 637 So its a F4? But what versions on Raceflight FC's uses F4? Hope this helps.

Hey. I have bought a used FPV quad. Im trying to connect it to betaflight, and it wont work. Just says "Faild to open serial port". I can connect to my other Quad, Wizard x220, and it work fine. I have tried to reinstall the drivers, but that did not help. What im i doing wrong? Also, im...

I have one cell missing when messureing my battery. I only have 2 cells showing: 3,72V. And the third one showing 0V. Also that makes ~7,45V. Could this be why my quad wont lift from the ground ? :)

If i messure the Xt60 contact it shows 7,45V. When i messure the cells, i messure on the charge cable, black to red 1, back to red 2, black to red 3.

Measured my battery and it shows: 7,45Volt (3S) Cell 1: 3,72V Cell 2: 3,72V Cell 3: 7,45V Does this means it is garbage?

I have recallibrated in Betaflight again. And also in the motors menu, i have tried with the receiver on. And all motors do as they should. Min throttle is set to 1050, and in starts at that. And all motors go up to 2000. Have checked the propellers several times, (have blisters from takin...

I had Blackbox turned on, downloading it from the "Onboard flash" now. 8MB and takes for ever to download :) Dont know if this has something to do with it, but when looking at for example Joshua Bardwell setting up a Wizard x220 he has a CPU load at 25%. Mine is around 75%.

Yes, is callibrated. And all motors works fine (i think) when running individual or all of them in Betaflight

Have checked the motors and propellers again, and they are correct. Now when i tried the right back motor stops, even at full throttle. When i throttle down to 0%, one motor keeps revving up. If i disarm, and arm again it is working for a little while then stops again

Thanks for your reply. I have checked that and also the direction of the motors. And they should be ok, but i will check this again. When i first arm it, it is just as it almost want to lift. But then one or two motors start to slow down and eventually stops. In my video, i have almost full...

Hello. I need some help here. This is my first quad, so i have followed guides on YouTube on how to set it up. The transmitter works in Betaflight, and all channel's look ok. I have calibrated the ESC's and it looks to be ok. I can run the motors individually in Betaflight and they seams to...