Search results

I was on a few other forums and saw posts that this behavior is somewhat normal on the bench.......so......I strapped a battery on top and it flies!!! normal too!!!! It does pogo a bit with the throttle which is very sensitive, have to get used to that. Overall I am happy....so far...

I did a board reset as you suggested. I have it now so only motor 1 accelerates at a slow pace, the other 3 hold steady. In Cleanflight, the master slider in Motors tab will cause the motors to be at the same speed all the time, no issues. It is only when I use the throttle stick on the tx...

All the ESC's are flashed with Turnigy Plush 60A 14.9 which is the latest. A little puzzled by this since the esc's are Favourite 30A. Now M1 & M3 accelerate on their own. Before it was 3&4. In blheli, I set each min and max to 1000-2000 and write setup. when I disconnect and connect...

I am also randomly getting from my receiver "telemetry lost" "telemetry recovered" on occasion. This can repeat itself every 2 seconds when it occurs.

I was able to calibrate the esc's. Now when I move the throttle stick up a little bit to start the motors, m1 and m2 are at 1070 and holding their values. M3 and M4 start climbing and get faster and faster without moving the throttle stick. Not sure why.

Armed with a switch and the props do not turn when armed. This morning, it functions normally. Only the throttle is starting the motors. Not sure how it got corrected on its own, but I am happy about it!. Now I have to make adjustments. The motors do not all start together. M1=1117...

hi. my Taranis X7 and FRSky X4R receiver are bound. when I arm the motors, the throttle, yaw, pitch and roll all turn the motors!!! anyone know where I should start? Using Cleanflight.