Search results

Thanks for the info! Hopefully this will get the quad talking and make it compliant to the transmitter. I’ll see what I can do with the info to make it work.

Correct the transmitter is bound to the receiver and the FC is connected to the computer. I have tried to flash the FC, but it shows an issue with the Bootloader. I’ve done the download of the Zadig and the other download, but I’m not sure how to apply it to the cleanflight program to make it...

I have a SP Racing F3 V1 board. From what I understand it already has cleanflight installed, the main issue is that I can’t get my Flysky I6X to be seen by the computer to be able to be seen by the computer.

This should not be this difficult! Plug in set up fly! That’s the way it should work! I can tear a cat apart and put it back together, yet I can’t set up a stupid little drone! What a pain in the butt!

Okay so I put the SP racing F3 board in with cleanflight. I can’t get the boot loader patch to apply to the cleanflight. In fact I can’t even find it after I spent the time to download it. I’m about to take a hammer to the drone and forget playing with any bind and fly set ups!

I was planning on using this for a tilt rotor drone that I was going to be putting together, but I could probably pick up another one for that drone when needed.

Alright, so I located an SP Racing F3 V1 FC in my stash of goodies! This from what I understand to an a Cleanflight already. I’m thinking about changing out the CC3D for this! Probably would be a lot easier to deal with than flashing the CC3D.

Okay sounds good. I’ll do cleanflight then.

Thanks I’ll see if I can reflash the cc3d to betaflight.

1: Receiver is plugged in to the battery pack and also the computer. 2: The transmitter is bound to the receiver and shows that it is connected to the receiver when turned on. 3:My guess is that it is connected. 4:, 5: I’ll have to do a little more looking at the settings. On my first attempt I...

I have a DYS 250 folding drone and a Flysky FS-I6X transmitter. I did the binding to the receiver and drone. I ran through the LibrePilot setup for the drone, but when I attempted to set up the transmitter LibrePilot did not see the transmitter. It showed no activity no matter what I did. Is...

Okay so I gave up on the oem 3CCD fc that came with the quad. I bought a Naze32 Rev6 and im trying to figure out why when i plug it into the computer it is not seen to flash or update. Ive tried different cables and ports with no success. Any ideas? the computer doesnt see the fc. it makes a...

That's what I thought I was going to have to do. Thanks

Yes the areas that have a + & - on the board is for power and ground to the board correct?

Here is a picture of the power and ground points that I'm going to have to wire in. Looks like it's another trip to the hobby store tomorrow for a few more items. I was there today for plugs for wiring in some lights.

What I've done so far is remove the servo jumper wires and cut one end off to hard wire it to the KISS FC. There is a Power and Ground pin that I'm going to have to connect also. The original CC3D FC used one of the servo wires from the main board to power the FC.

This is the top side of the quad. I have already removed the upper frame panel to get to the FC.

So maybe that's what the issue was when the CC3D was attached. That may be why the FC would not see the TX when I was attempting to do a set up on the computer.

Originally that plug powered the FC and everything. That was the only power source.

This is the bottom of the dys 250 frame.