Search results

I switched my motors around on different esc's and they did the same thing so I tried new motors and some of them worked. I am going to send back to my supplier three motors that would only chatter.

I am attempting a tune on the FCB and I reset the "Z" axis. What did I do??? does this affect anything???

I'm having the same trouble. I have connectors on all wires and only have one motor spinning up while one doesn't do anything and two motors just click. I'm going to desolder one motor and solder it direct to the ESC and if that works I'll do it to all four motors, but I'm skeptical that...

Maybe 4-6 weeks flying twice a week

I have a Syma XC5-1 and although it flies ok it has developed a loss of power after only about a minute even if I change the battery. I would look elsewhere rather than the XC5 model. It is very cheap and were I to do it over I would look at the Tarantula or other slightly upgraded units.

Also check your prop nuts to make sure the prop is spinning as fast as the motor. ry switching the opposite motor to that one and see if the results change.

I just got back from an attempted flight. After trying my home built quad (DYS 30amp SimonK ESC, 950+- motors) I took the quad out to a field where I fly occasionally. I have had a problem with one of my motors or ESC- not sure which- in that the motor starts very erratically seemingly not...

Well no replies but I am moving toward a finished flying DJI 330. to answer my some of my own questions: I tried many times to bind to the Naze32 board with my Spectrum black receiver, but always unsuccessfully. So I bought a PPM orange receiver and it bound easily. The problem seems to be...

can this receiver be bind' without being connected to the FCB if I have power to the receiver, or is there additional data being transferred through the FCB as well at the time of binding? Also is anyone familiar with the Naze 32 with pressure sensor? I am only getting the blue light on when I...

I am unable to get my radio to indicate any communication to the FCB ( naze 32) while on Baseflight. moving the throttle forward and back gets no movement of the colored bar at the throttle. The problem may be that I have the RX cables out of order on the FCB but I think they are right. I need...

Using direct connections may be the only way I'll ever get this thing in the air!

Near as I can tell those are all too big. I measured mine to be 3mm not 3.5, plus you never know when they will get here till they send you information after purchasing them!

I ordered some 3mm connectors from Amazon only to find out that they will be delivered sometime in Sept or maybe Oct. Where can I find a legitimate dealer that sells 3mm connectors and will get them to me next week???

Well this is working too well compared to previous flights so I'll just leave it as is for a while. As a side note I changed from 6" props to 5" and the quad would not lift off the ground with the 2s battery. I was trying the smaller props to see if it were even milder in response- well its...

I think I get it thanks... My receiver is not PPM. Not yet anyway. I may change it out if this works out well...

I'm building a 330 quad and bought the Naze 32 with barometer in it so I could hover. I'm assuming I'll need to set a switch to accomplish the use of the barometer. I'm using BaseFlight but don't know how to set a switch position. Can anyone school me? Also I guess I need to run an extra...

I see what you mean, that would technically adjust the maximum throttle to the same value as lowering the actual voltage of the battery- which is what I accomplished by changing the battery to a 2s. The one thing I accomplished was to change the yaw, pitch and roll along with the throttle at...

Maybe but I don't know how. Tried adjusting curves on the DX6 but didn't like it much.

My second quad was-is a VooDoo 280 racing brick. Although it has no redeemable aero nautical abilities it screams around the sky until an immovable object hits it. With me flying that is quite often- lots of prop changes... I have learned to fly my wifes Syma XC5-1 rather briskly and wanted...

what happens if they are not flashed???