Recent content by Zer0

I did. But the v5 version is what i have. For the price wad not worth my frustration. Now its in small pieces. :mad:.thanks again.

Just changed all four motors and still the same must be in the board that will be next thanks again

Thank you for responding. I did not change the motors yet. But I did just find out something new. When I power the unit up and give it some throttle the lights will flash and stop. When I bring the left controller down it reset automatically and I can slide on it up again but I get the same...

Coney island

Would a bad motor cause this problem? or would it not fly right? I didn't get that answer. has it happened to anyone before?

Beautiful. Sounds good. Thanks alot. Hope it works. I'll respond to my findings.

That's great advice. I would break in my rc motors long ago. I figure to keep them matched and all new. That confirmed what my initial plan was going to be. Thank you so much. I wouldn't hurt to run a full battery at low speed for 10 minutes or so would it as long as they don't get above warm...

I thought the ones i bought were suppose to be a little better but that's what they are telling me. I figured i use a new so there is no difference in power or action. Would that bad motor make machine act like it does? ? Anyone familiar with this? I'm going to have a bunch of questions when it...

There was no loose connection. (Unfortunately ) one motor is very week. Could the bad motor make this happen Or would it just not fly properly? This just opened up a big can of questions i need to ask now. ..would it be in my best interest to replace all motors so they are same brand and are...

Great, thanks again. Hope that is problem. Will post results when I get a chance to look at it.

Where was the bad connection? I did full power it holding it still on the ground and it seems to run than stop at the same amount of time. could be bad connection though, just wondered where yours was.

All batteries are new and charged, i swopped batteries with my neighbors xc5-1 and Controller and either combination still will not work. Thank you for responding.

First time on forum, I have a Syma xc5-1. Used quite a few times. Quad lifts off ground then suddenly drops and flashes. and will do the same over and over. changed batteries and switched controller with neighbor for a test, still nothing. one of the motors seems to be week when I put...