Nothing... What so you guys think about soldering one of these in the Tx controller antenna, to block the 5.8 ghz harmonics?
http://www.hobbyking.com/hobbyking/store/__76494__Low_Pass_Filter_For_2_4GHz_Antennas.html
Did some random channels but that didn't work. I've indeed seen more people switching true every channel with succes. Going to try that. Fingers crossed!
Well, I tried everything today.
Voltage checked. Took the transmitter apart. The antennas had a nice and solid ground.
I tried putting in batteries again. Still interference with the video. Even with the antennas half a meter or more away from each other!
I'm starting to think its cheap and...
Yes I can check the voltage. Going to try that one out today.
Maybe I've not been clear. I'm sorry for that. English is not my native language. It had nothing to do with the quad side. It's the controller you hold in your hand with a lcd attached to it for FPV. It has nothing to do with ESC or...
True that. However the cheap circuit board is always on when FPV is on. So that shouldn't be the problem. Especially regarding the problem was before mounting the board.
I could try taking it out again and putting in batteries again. But a TX doesn't draw that much amps right? Normally it runs...
Probably not. First time flew it without FPV and only noticed problems with the second FPV flight. Crashed the second time with FPV.
However I doubt it's from the crash. The problem only occurs when I turn on the transmitter.
Hi guys.
I build an budget FPV racing quad a while ago, first flight flown it without FPV, second flight with the quanum FPV goggles. Crashed the thing with the goggles because I was loosing video. Later fixed the lcd to the transmitter and the video connection is perfect, however when turning...
Are you using self-level? Are you 100% sure your props turn the right way? I've made this mistake before. I haven't flown with Steveis (however I flashed the quad a month ago :P) but the hk firmware should get you airborne. Poor pid settings can also result in this problems. Also make sure your...
Cool. I didn't know those existed. Wish I have discovered them earlier. Should work fine according to the specs. But I'm no expert lol.
Edit: don't know for sure but I can't seem to find how it is connected to the flight controller. Either some kind op data communication or those color named...
That will be impossible to fly. Every motor needs its own esc (electronic speed controller) to compensate for many various reasons why the flight controller various speeds on each motor individual. Even hovering would be impossible. Furthermore it wouldn't even work. If one motor is off timing...
Hmmm stil got problems with the self-leveling. If I set AAC trim setting for pitch up to 1000 or -1000 is doesn't matter. Keeps flying backwards after airborne. Any ideas?
Edit: lol, I crashed it already. Broke a part of the frame and the FPV antenna. So ordered a new one. Also ordered a 150...
I bought the mini on accident lol. Wouldn't recommend it to anyone building a normal 220-250 or bigger quad. It's too small. Buttons and screen are also smaller. Resolution of the lcd is very good. It does fit the Chinese frames. Further is it just the same as the it's big brother. But it's...