Recent content by spinzer

I have the Flycolor bls slim 40 amp esc, this one exactly: http://en.flycolor.net/index.php?c=category&id=201 They say it supports dshot 600, however i can find no information on this. Blheli suite reads the mode as multi, see attached picture. Now one of 2 things: Does it need a firmware...

Thank you Sir, i found that my firmware is version 0.2.0

My quadcopter returned from the shop i did the upgrade with and they installed a helio FC and Emuflight on the FC. I cannot get hold of the technician as he is officially on leave so cannot find out what version of emuflight he installed. When i read on the emuflight download page, it says the...

Thank you Sir, i'm thinking about getting a frsky x7 i can get used. but might use what i have as it seems do-able from your responses, also received a response from frsky themselves which compliments your advice, so again thank you. I will update with the progress when i get started...

Does this help or only making it more unclear ? I tried to put it into context in a text file. Am i on right path here ? Will the latency and refresh rate of the DJT module and jr9x2 together with the R8XR frsky receiver be fast enough to run a racing drone ...

Digging in deeper into this rabbit hole i found another piece to the puzzle: Frsky themselves gave me this answer: You can put the DJT in D8 mode, bind the X8R in D8 mode (using the jumper, not the bind button) and it should all work for control using SBUS between receiver and FC. You...

(Reposting as i edited it too much to correct spelling errors so the mods made it invisible)

Digging in deeper into this rabbit hole i found another piece to the puzzle: Frsky themselves gave me this answer: You can put the DJT in D8 mode, bind the X8R in D8 mode (using the jumper, not the bind button) and it should all work for control using SBUS between receiver and FC. You...

Are you using the frsky DJT module ? And this receiver in the picture attached. Let me give you the background: I dropped my jr 9XII radio with frsky DJT module off along with my quad at a local store. Asking them to put in the new strix flight controller for me. They get back to me telling...

I have searched high and low in my country for something that can work to no avail. Can anyone tell me why a jr 9xII radio with a DJT frsky module with an RX8 frsky receiver will not work with my quad. a local LHS is trying to set it up but they say it wont work. I was told a few things but...

Wafflejock could you perhaps tell me if the new controllers support a pwm receiver ? i have a frsky V8FRII RX: https://www.frsky-rc.com/product/v8fr-ii-2/ If not is there a way to wire it up to make it work ?

Ok thanks, i think those controllers support cleanflight too ? its all i can get so if it supports butterflight, should be much better than the cc3d and libre pilot problems ? i know it closed proprierty software and i don't think betaflight will ever be supported because there was a fallout...

Ok thanks wow that bidirectional setup sounds good. My esc's although quite newish only supports dshot 600 though and blhelS not '32" I guess my only option then is to ditch my trusty old cc3d, never gave me 1 hint of a problem on my old setup. I will have to use my heavier 2200 mah 4 cell...

ok i have adjusted the p and i values i went as low a 6 on (i) and 3 on (p) at one stage down from 65 and 30 and thought i noticed a slight difference however at these low settings control response was almost non existent. I'm starting to lose hope in this controller. There is nothing wrong...

Here are the other settings that can be changed ?