Recent content by Rob Reeves

I practice on a sim Phoenix, and Fpv with a buddies setup. Been flying Rc for 20 years off and on

I did the same exact thing, I bought a 250 blackout clone from Value Hobby, $15.00. went with the g force motors and 12a simonk esc. then bought a PDB from Banggood. Naze32 from MultiRC. A x4r Sbus receiver from Hobbies Aloft. I have spent about $140 in with no FPV gear yet. I have been...

yup motors are in the reverse postions. DUH!:oops:

I'm not 100% sure but in cleanflight CLI, it would not except PPM command or SBUS, and only RX Parallel receiver could be selected. I think it must be the Naze. So I used my V8r7-II, and was able to power up the motors. But when at full throttle it would not lift, and eventually tilted and...

Got it working thanks for the input

here

ok my V8r7-II is working in Cleanflight

I select rx serial sbus, and hit save, but when I come back nothing shows selected

Pics of my quad set up

Here are my screen shots from Clean flight

Yes first quad first build, no the channels do not move in either base flight or clean flight any guidance is appreciated

My issue is the naze32 rev5 is not sending signal to the rec'r. The receiver is binded, and telemetry is working. I have power to it. I'm using Base Flight. i hooked up a non-Sbus reciever and still no control between the Radio and the quad. Same issue with Cleanflight. I am able to...