Recent content by MoxMox

Ok ive done the ACC calibration and thats was all good. The receiver test is all good. Everything seems fine no errors on the board, just the fast beeping and twitching of the motors :(

Yea they normally make a sounds every second but this beeping is alot faster then normal... Hmmm calibrate the ACC?

Ok I have the receiver all working your a god send mate. Just the problem with the motors twitching and beeping fast. I can arm the board and nothing will work, jkust beeping and fast twitching any ideas??? Thank HEAPS

Ok so I have tried doing what you have said but the receiver is not getting power (you only need 1 5v+ and 1 neutral) im guessing thats where I went wrong, I dont really get what your saying... Im guessing theres no power jumper going to the receiver. Sorry you must be sitting there thinking...

In that bottom diagram you only have 3 jumpers from the receiver going to the KK2.1.5?? It should be 4?? - Sorry im very new :(

Hey guys im having some really hard times trying to wire the X8R and the KK2.1.5 together. Please help me out. I have attached this link to help out. Thanks so much for any advice.

Hey mate thanks for the reply. Yes the motor smoke when its turned on. So pretty much when I get the new Q-Brain I shouldnt use the motors that have been smoking as they could short the new ESC? I can open the Q-Brain but I cant open it up to see the other side of the board as there must be...

Some photos to help out visually

Hey guys Im very new to building Quads and this is my first build. Im building a Quad with the following specs: KK2.1.5 , Q-Brain ESC, 9XR pro controller and X8R receiver, 2200mAh 5c Lipo. While I was building it, I was soldering the connectors onto the q-brain wires, I turned it on for some...