Recent content by MisterSifter

Yea I did that a couple of times but thanks, it turned out to be the trim settings, I thought maybe it was the ESC calibration. Its very sensitive on the sticks which I need to look at but its hovering nice now. The new problem is the FPV camera isnt working via the FC but it works on its own...

Just risked my first flight, handles strange, its always trying to go everywhere except up so im having to fight to keep it in a hover, glad to get it flying anyway, lots of tweaking to do.

ok I thought id elaborate on this, the problem is im aching to do my first ever maiden of a racing quad but when I apply a little power the motors spin really fast, im guessing if I put props on it will go into orbit at just 1% throttle, ive tried lowering the minimum throttle settings in...

Im probably having a thick moment but I cant find any info to fix something so simple. The problem is im getting the full 100% range of travel from the sticks but when I go into my models mixer settings the graphic is showing that im only getting 50% travel on all axis's. Cleanflight shows im...

You mean to short the boot pins? I actually find them to be too big for the job, I use a bit of rolled up foil, as long as you put a bit of solder on the pads first it never fails. In fact I think not applying solder first probably causes a corrupt flash. Ive got as far as getting to motors...

Ive discovered the RX has an issue where you need to apply pressure to it for it to work, actually pushing on the chips on the board makes cleanflight notice it. also touching both antennas makes it work, basically it works when you handle it but not when you let go if it.

Ive found the issue, the pins inside the RX connector are a bad contact, when I push the wires in it works, the sliders move in cleanflight now.

Well I woke up this morning with an idea, I tried putting solder on the boot pins instead of tin foil and its flashed ok. Im going to contact the seller and see if he can help me out, see if he remembers where these wires go..

I just threw it in the bin lol its only £100 im gonna go onto FPV planes, good old fashioned rock solid reliability.

No never flown it, only able to power it up, everything lights up ok it seems. I tried to install my own spektrum RX but it didnt work out, so went back to the frsky. Now I cant connect it to cleanflight anymore, when I try to flash it says cant connect with bootloader even though the pins are...

Yea tried binding and still cant get the RX to work in cleanflight. Totally stuck dont know what to try next.

No, I thought about trying that but I figured it was ok because it says "telemetry lost" when I turn the TX off. I will try binding again. Just watching a video here some guy talking about firmware conflicts between TX and RX, something about internetional and EU conflict, sadly he didnt...

Hi all, im new to this FPV racing, never actually flown yet even though ive had the gear for weeks and my problem is I bought an Emax Nighthawk X5 that had a Frsky XSR RX and noticed he had 1 wire from the RX soldered to 2 channels but I cant remember which ones (I should have took a pic, stupid...