I think i may have found the problem. I did try a 3amp ubec but it did not make a difference.
I was checking the solder connections and i noticed that one of the speed controllers is different. I originally had 4 DYS 20amp blheli speedies. One of them was faulty and the supplier sent a...
I think you are right. I think the Buck Converter is not giving a stable flow of current. They do state that they are 3amp rated but i have my doubts. The problem with the pdb, was that it was only giving 4.75 volts to the Receiver and Naze. As the Lipos drained down this voltage obviously...
I will check that. I cant remember whether i used a 3 or 4 cell pack when i did the Naze setup. Maybe that is the issue. I did have a PDB fitted underneath the Naze that had dual 5volt/12volt outputs. The 12 volt output gave out after a few flights. I was getting brownouts on the Receiver so i...
I built an ImmersionRC Vortex with parts from my Emax 250 Quad.
Vortex crash kit 1 and 2
Carbon fibre bottom plate with no electronics.
Naze32 Acroflight
4 off DYS BLHeli 20 amp speedies
Emax MT2204 2300kv Motors
2 mini buck converters set to 6 volt for receiver and Naze32. The other set to 12...