Recent content by Kremit

I've been completely unimpressed with HGLRC products. I've bought 3, 3 failed, and they will not stand behind their products. Never again for me...

I've built a 250 drone, everything seems to be working. I've done a 24" hover, moved around at very low speeds, things seemed to be working, but then the coptor started diving to the front left. I'd be in a hover, and bang, it'd on the ground. The last time, it broke the prop, so I replaced it...

I could never find any real documentation for the board... either of them.

I actually found it after many hours... you have to use UART3 for the serial port, and make sure you have sbus as the type. That was a little rougher than it should have been...

OK. I have an HGLRC F3 V4PRO flight controller, a Frsky X4R 3/16ch receiver, and a Taranis X7 xmitter. Cleanflight configurator seed the FC fine, but no want I can the Rx to talk to the FC. I'm using the SB port with the right pins/polarity, and hooked the signal wire to the F3 SIN pin for SBus...

Hi All... joining up to talk to others about my new addiction. Been messing around with the RTF 'toys' for a couple of years, and now am building my own...