I recently replaced a burnt out FC on one of my quads with the CL RACING F4S. I'm trying to get the smart audio working now. Does anyone know which pad on the FC the smart audio wire from the vtx should be connected to? I'm just now venturing into smart audio and don't know much about it.
So I got this rechargeable battery for my new Taranis QX7 in the mail yesterday and I'm a little confused as to how to charge it. I can't charge it with my big charger that I use for all of my quad batteries bc it doesn't have a main batt lead like a xt60 or jst, only a 2S balance plug. Can I...
After building and flying, building more than flying because I'm not so great at the flying part just yet due to the fact I work so much leaving very little time to fly. Ever since I started I've just been using the fs-i6 that came with my eachine wizard "ready to fly" when I bought it. Over the...
I don't race, not yet anyways I've been flying about 8 months, possibly a little more..but between 2 full time jobs I can't fly near as often as I like. I've been doing basically nothin but acro mode flying, stopped using level mode ab 2 months ago. I find flying in the goggles incredibly...
Personally I'm thinking a 2306 2650kv motor is going to be a bit too much horsepower for such a light frame..but then again I am far from an expert on the subject.
Of the frame? Not mine in particular, just now headed to the house to get it out of the mail box. I'll post a pic of it from the site I bought it from.
I finally received my Floss 2 frame in the mail today. Trying to decide which motors I want to use with it. I have a set of Brotherhobby Returner R5's (2306 2650kv) sitting around waiting for a frame. My question is..would these motors be too much for such a light build, will they work well with...
I've decided to finally make the swap from PPM to ibus, and considering the fact that I have a severe technological impairment..me and technology just don't get along, I'm not quite sure what to do. I use the Flysky fs-i6 on 3 different quads all of which I built, not bought RTF or anything, and...
So I finished installing the DYS F4 on my main, and favorite quad last night. Hooked it up to betaflight to flash the latest version of firmware just in case, then set everything up in configuration, setup osd etc..I spun up all 4 motors to make sure they were good (and all 4 did just fine.)...
Well, I had just purchased 2 dys f4's for both of my quads. Started installing the first one last night and within the first few minutes 2 of the solder pads fell off the board. Very upset about this considering it is supposed to be one of the best FC's on the market currently. I will be sending...
Well I've got other problems with the board now. As I was soldering my esc signal wires and the radio rx wires..the freakin solder pads fell right off. I know that I didn't over heat them. My iron was set to the lowest heat setting and the heat was only held to each pad for a maximum of 2...