Recent content by Holden

Yea I've seen that before. Pretty cool. I found a thread on RC forms of a build a guy did, not sure where the link is at the moment. I need to look it over again. But yea we are going to use a separate FCB to try and get the two different modes configured. On the thread the guy used a KK FCB...

Oh it's that much better? Ok ill defiantly get the flash tool then. Thanks. Question. You keep saying for the "acro board" what do you mean by that? Is "acro" short for acrobatic or something? Also just so you know I'm not building a quad-copter. I'm building a dual copter, and this whole...

http://www.amazon.com/gp/aw/d/B00NPRRZNU/ref=mp_s_a_1_2?qid=1426139377&sr=8-2&keywords=kk2.1

As far as I know I just have the normal kk2.1. I'll provide a link to the one I bought. I fixed the problem though. I went to my local hobby store and tried out other ESCs and they worked perfectly with my set up. I ended up selling my Hyperion ones and replacing them with some Hitec 40A ESCs...

Do you have any recommendations on which USBasp ISP programmer to purchase? I was going to get this one http://www.amazon.com/Hobbypower-USBasp-Programmer-Multicopter-Control/dp/B00DU4A58A/ref=cm_cr_pr_product_top

HW Ver 2.1 FW Ver 1.9S1 Steveis Ok ill try that. the equipment for flashing it isn't very expensive anyway

I have tried arming the ESC through the board with the transmitters minimum throttle at 0% and at -100%. Does not make a difference, the ESC will still continuously beep the minuet I arm then unarm the KK2.1. The ESCs still don't respond to the KK2.1s inputs unless its in throttle pass through...

Hi. I was wondering if you resolved this issue. I am having the exact same problem with my KK2.1 board and Hyperion Atlas ESCs. I am at the point where I feel like buying a different set of ESCs would be the best thing to do.