Recent content by Gareth

Hi, Do you think the following motors will be sufficient? MT2213-935KV Brushless Motor

Thanks for the advice, Gona get on with it so long... This is the section of the frame i have so far... busy printing the connectors and center plate. will mount a fiberglass plate on top. will only design and print the motor mounts when i get the motors more questions to come...

Quick eval on the info you gave... B is the distance between props using the sizes i initially stated and you advised on. A is the new distance between blades if I were to make the frame 600mm wide using 12 inch props Props are quite a bit closer with that little adjustment, does it look ok?

Hi, Thanks for the reply. What do i intend it to do you ask? Well my Mom lives literally 20 houses up the road from me an I was thinking a payload of water balloons would be a good idea... LOL just kidding... sort of... lol Seriously, I never thought about allowing the frame to fold up, ill...

Hi, I'm a South African who wants to build my 1st Quad. I have the aluminum tubing for the frame. The copter will be about 840mm - 1050mm between motors I have received my ArduCopter with GPS which I ordered online. Waiting for my LiPo (11.1V S3 5000mAh 30C) <- Hope this is OK I need...