Recent content by FPV Petrey

I figured out my problem. I had my esc hooked up to ppm. I changed it over to channel 3 and it calibrated. The only thing now is it seems to be full throttle before I hit the halfway mark. Running it from cleanflight it seems to be in the range of 1000 to 1350. Any other settings that need to be...

Layouts the same. I could be wrong. I'm just making a guesstamation.

Boom! http://m.ebay.com/itm/HW30A-Brushless-Motor-Speed-Controller-ESC-For-RC-Airplane-Quadcopter-Helicopter-/371960296663?txnId=937651957024 I looked forever trying to find what they were based on. This is what I found about them...

and......

Ebay specials! I have to post 3 times before I can post a link.

hello all! I'm building a 3D printed quad (hover ship frame) and needing some help. Im new to this so I might not have some settings right. I'm to the point of calibrating the esc's but they are only beeping 3 times at powerup. I'm only working with one right now hooked up to a 12 volt power...