Recent content by eek

So you think I can just use nyloc nuts and it will have enough strength to withstand the unwinding force? I know how to reverse, but then it will be front-left and rear-right CCW and, for example, when running calibration in CC3D software, it presumes that your quad has front-left and rear-right...

Well, I probably created thread in the wrong part of the forum. The titles are quite overlapping. Hope this gets deleted.

Hello, today I tried to lift my completed quad into the air in my room. Well, when it got 5 cm off the ground, prop nuts came loose and 4 props and 4 nuts flew in all directions, one even hit the TV:( seems no damage though.. Basically my motors spin the wrong direction compared to nuts...

Hello, today I tried to lift my completed quad into the air in my room. Well, when it got 5 cm off the ground, prop nuts came loose and 4 props and 4 nuts flew in all directions, one even hit the TV:( seems no damage though.. Basically my motors spin the wrong direction compared to nuts...

Hello, I have cc3d computer and RangeLink PPM receiver. How do I connect these? All the manuals and tutorials tells to connect just one wire which consists of black, red, white wires if using PPM, like this...

Well, my budge for quad AND goggles is about 700-800 EUR. I don't know how much of it I can spend on FPV system specifically as I still lack knowledge to make these decisions. If you could provide some suggestions I would be very grateful.

Any 1.3 / 1.2 Ghz camera + transmitter + receiver + goggles recommendations for 250mm frame?

Hello, I currently have several line of sight RTF quads and am quite comfortable with them. I would like to build FPV quad for landscape/urban exploration (fly in buildings under construction, under bridges etc.) but currently have little knowledge about them. Basically I would like the biggest...