Recent content by DaveFPV

Hello, so i had a bit of crash and my motors cut out but still had power to my flight controller as i still had video. But as i was inspecting the FC i noticed a chip had been damaged. I was wondering if anyone could tell me if 1. i can still use this board and 2. if that was the cause or was it...

Run cam split mini 2, but tried it with the foxeer monster v2 as well but same issue, the vtx is a tbs unify pro v3 5v, the split is powered from 5v and the vtx 5v also but diffrent pads though.

Shall i put some tape on it just incase? And i will shorten my wires also. Would an lc filter help at all as i have seen alot online say that might help?

Yeah soldered both to the same pad on the fc as i have a aio.

Already have one, sorry forgot to mention that.

So i think i have worked out why i was getting slightly diagonal lines in my fpv feed, esc noise. Just wondering if there is a way to filter this out on betaflight. Here comes the fun part, i can only do it via the osd as i may of broken the micro usb port on my flight controller, i was thinking...

Okay thank you, sorry for the late reply.

Hello, silly question, but what is the lowest voltage for a 2000mah 6cell 7.2 v Ni-Mh battery? Thank you in advance

Got a new pcb sent out, all working fine now, thank you

No they came off, have looked for replacements, but no luck.

Hello was wondering if anyone could help me, well i was messing with the run cam split mini 2 settings, and well i accidently turn off the auto power up option. Well i have no buttons so can't turn it on at all, hoping theres another way round it. Thank you in advance

Can't seem to find them

Thank you so much :D

Hello just wondering if anyone knows where i can get a replacement ribbion cable for the Runcam Split Mini 2, mine has kind of died (well thats what i think it is) Thank you in advance.

Yes only 2 motors are running and firmware is the lastest.