Recent content by Captaindan87

I will build this via your instructions and succeed.

Next question, can I change the camera?? If so, any recommendations

This was very helpful

What is the correct steps to start and caibrate before take ooff. Any advice? If then maybe I can taken off and control it properly without returning it. Let me know if u guys have a formula way of turning it on, calibrating, and take off.

Do you think this is the problem?

Should I try resetting it when it is facing the correct direction . BTW what is headless mode, when should I use it , and why should I use it. How does it benefit versus high /slow mode.

One more question, what is headless mode, and how does it work differently from high /slow mode. When do I use headless, why should I use headless

Should I try reseting the unit with the unit facing correctly away from me???

The green light is suppose to be the front right? If so, then it is flying opposite

@holtneil what do u mean make sure the "quad is the right way round if all axis are back go front" I have no idea how to understand that phrase. Can you please speak in lamens terms, because I didn't understand it. My copter Flys opposite, how do I fix it??

I bought it yesterday I'll just return it and hopefully won't encounter the same problem with a new exchanged x8

@Quadcopter102 Hey kid, I found these sites diydrones.com droneflyers.com U might want to call them up and have them change their names!!!! Lol we are not in australia. This is america, and in America we call these "dronez" not "quadcopters" sorry to burst your aussie bubble, but u...

@GJH105775 I opened this fresh out of the box and I didn't reverse any controls, so whatever is set up camelike it is from the store

I don't know how to discover or even do that, can u provide some specific instructions on how to determine that. I'm assuming the TX is the transmitter. I'm not a drone nerd yet haha. @GJH105775

It is so strange that no matter what mode I'm in , it Flys opposite. I've built rc trucks and have seen a similar issue when crossing the power cable wires to the motor. But I think I'm screwed and will have to return it