Recent content by 1251452

  1. 1

    Betaflight 2.8.0-RC3 Always full throttle

    It looks like when I bump up the throttle, one motor slowly climbs to 100% throttle while the others back off. Why?
  2. 1

    Betaflight 2.8.0-RC3 Always full throttle

    Update: New problem, I am extremely frustrated now as there is a completely new problem. The old problem is gone, but now after reflashing the board, the quadcopter is not stable. It wobbles around and then crashes. I have absolutely no control. It wobbles like there is too much I, but I is...
  3. 1

    Betaflight 2.8.0-RC3 Always full throttle

    Thank you for your reply, I have checked that the rx is in working condition, that all the channels are going the right way. The throttle is fine, as I can arm the board with throttle being at the correct 0 value. I did a little bit more testing and found the problem to be air mode. When I...
  4. 1

    Betaflight 2.8.0-RC3 Always full throttle

    Hello everyone, I have installed betaflight 2.8.0-RC3 on my naze32 rev 6. I have disabled oneshot, and have set a switch to arm and airmode. My pid numbers have been transferred over from the last firmware. However, upon arming, the motors throttle up and the quad starts climbing. The...
  5. 1

    Betaflight with Airmode Grief

    Anyone?
  6. 1

    Help with baseflight and naze 32

    www.youtube.com/watch?v=rj6IXA2hDW0 It's a little outdated, but the information is good
  7. 1

    Help with baseflight and naze 32

    It's not the numbers that's important, how is the travel of your throttle and rudder? Did you try assigning a switch to the arm mode?
  8. 1

    Betaflight with Airmode Grief

    anyone have any ideas?
  9. 1

    Help with baseflight and naze 32

    check that throttle goes to minimum accepted level, quadcopter is level, and rudder travel is sufficient to trigger the arming of the board. You could try assigning a switch to arm the board. If it still doesn't arm, Check all the connections
  10. 1

    Help with baseflight and naze 32

    can you confirm the board is arming? green light appears?
  11. 1

    Help with baseflight and naze 32

    When you say upside down, do you mean, literally, the underside of the board faces up? In that case, you cannot arm, you need to either flip the board right side up, or change the orientation inside configuration. Does the green light come on when it arms?
  12. 1

    Help with baseflight and naze 32

    Yes, that's used to enable ppm output from the rx. On the wiring diagram, you can see jumper between 3 & 4
  13. 1

    Help with baseflight and naze 32

    yes, on the d4r II
  14. 1

    Help with baseflight and naze 32

    Picture of wiring? Have you set up your serial input on the configuration? Enabled ppm on your board?
  15. 1

    Betaflight with Airmode Grief

    Hello everyone, I have recently tried to get betaflight on my naze32 rev 6, because I wanted airmode on the quad. Upon getting the board sucessfully flashed, I armed the board, and tried to spin up the motors to no avail. The motors didn't make the startup sound, nor did they spin. I tried...
Top