Ryan63
Well-Known Member
Okay so heres my story. Im new to the hobby. I started off with a walmart brand sky viper. Got the basics down with that quad. After losing one on top of my local metro pcs store :/ as soon as i started learning how to maneuver the cheap little "stunt drone" i fell in love and wanted more. So i traded my amp and subwoofers right out of my trunk on a facebook swap page for a quad i know nothing about. It was just the quad. No tx. no battery. But its a 250. It has a camera and a fatshark fpv tx. I bought new blades, gemfam 5030. 2 new batteries. Bias 1300mah 50c 4s. A turnigy accucell 6 charger. And a radiolink at10 10 channel tx with the r10d rx. I know nothing about this quad. Or really any other quad because im new. And no one i know flys. Im at a stand still here. See, i binded the tx and rx and i know its binded cause ive watched videos on how to bind and the screen on my tx shows telemetry. Or signal. But for the life of me idk how to get this dang thing in the air. I didnt have the correct plugs to plug into the rx so i made my own.. One of the many many questions i have is the wires coming from the (motherboard)? If thats the name of it, there are three right? Power ground and data. Right? If thats all that comes from the board into the rx then im good. I have them all hooked up correctly. But i cant get the quad to spin the blades. It wont move. I plug it in. It beeps. And the props jump once in a while. But nothing.. ANY help would be so much appreciated. The "motherboard" is double stacked. But the wires that go into it for rx are soldered. There is no plug option. Just 3 wires coming out of it so i hooked up my rx to it and its obviously right because its linked up. If anyone knows anything about this please help me out. Any info will be greatly appreciated. Thanks. Ryan.